Zebra 110XiIII Plus Series - Page 108

13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-3
Maintenance Section 4
Retiming the Upper Drive Arm .................................4-60
Replace the Cutter Motor.......................................................4-62
Remove the Cutter Motor ..........................................4-62
Install the Cutter Motor..............................................4-63
Replace the Transmissive Media Sensor ...............................4-64
Remove the Sensor ....................................................4-64
Install the Sensor........................................................4-66
Replace the Ribbon Take-Up Pulley .....................................4-67
Replace the Media Take-Up Pulley .......................................4-68
Replace the Rewind Plate ......................................................4-70
Replace the Ribbon Sensor ....................................................4-71
Remove the Ribbon Sensor........................................4-71
Install the Ribbon Sensor...........................................4-74
Replace the Take-Label Sensor .............................................4-75
Remove the Sensor ....................................................4-75
Install the Sensor........................................................4-76
Replace the DC Stepper Motor..............................................4-78
Remove the DC Stepper Motor .................................4-78
Install the DC Stepper Motor.....................................4-81
Replace the Black-Mark Sensor ............................................4-82
Remove the Sensor ....................................................4-82
Install the Sensor........................................................4-83
Options...............................................................................................4-84
Install Options........................................................................4-84
Supply Spindle...........................................................4-84
Adjust Spindle Tension..............................................4-85
Bifold Door ................................................................4-86
Rewind Option.......................................................................4-87
Parts List ....................................................................4-88
Install the Rewind Option ..........................................4-90
Install and Adjust the Drive Belt Tension .................4-91
Install the Take-Label Sensors...................................4-92
Adjust Rewind Mode .............................................................4-93
Adjust Tracking .........................................................4-93
Adjust Tension...........................................................4-94
Adjust Peel-Off Mode............................................................4-95
Lower Roller ..............................................................4-95