Page 2-50 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Section 2 Operations Overview
Default Gateway
This parameter allows you to select the IP address through which the network traffic is
routed if the destination address is not part of the local network.
Press the left oval key to move to the next digit position; press the right oval key to
increase the value of the digit.
Press NEXT/SAVE to display LANGUAGE.
Language
This parameter allows you to change the language used on the front panel display.
Press the right or left oval key to display other choices.
You have now completed the entire configuration and calibration sequence. Press either
NEXT/SAVE to save all settings, or SETUP/EXIT to go through the selections again.
Note • This display does not appear unless a ZebraNet II PrintServer is
installed.
Default: English
Selections:
English, Spanish, French, German, Italian, Norwegian, Portuguese,
Swedish, Danish, Spanish 2, Dutch, Finnish, Japanese
DEFAULT GATEWAY
000.000.000.000 +
LANGUAGE
ENGLISH
To Next Page
Loading...