13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-135
Maintenance Section 4
Install Reader PC Board Assembly
1. Remove the harness connectors from the old reader board assembly and connect
them to the new reader board assembly.
2. Refer to Figure 4-93. Mount the new reader board assembly onto the printer using
the previously removed mounting hardware.
3. Reconnect the antenna carrier assembly cable to the reader board assembly.
4. Refer to RRP No. 2 on page 4-16 and reinstall the electronics cover.
5. Reconnect the data cables and AC power cord.
6. Press and hold CANCEL while turning the printer On (l).
7. Release CANCEL after the DATA light turns off (approximately five seconds).
To Next Page
Loading...