Zebra 110XiIII Plus Series User Manual

13185L-002 Rev. A 1/24/06 110XiIIIPlus Maintenance Manual Page 4-69
Maintenance Section 4
Figure 4-42. Replace the Media Take-Up Pulley
7. Slide the spacer and the pulley off the shaft.
8. With the recessed side facing away from the main frame, slide the replacement
pulley onto the media take-up shaft.
9. Slide the spacer on the shaft.
10. Reinstall the E-ring.
11. Reinstall the rewind drive belt.
12. Refer to RRP No. 7 on page 4-26 to adjust the tension on the rewind drive belt.
13. Reinstall the main drive belt.
14. Refer to RRP No. 5 on page 4-23 to adjust the tension on the main drive belt.
15. Reinstall the power supply.
16. Reinstall the electronics cover.
17. Reconnect the data cables and the AC power cord.
18. Turn the printer On (l).
Media Take-Up
Pulley
E-Ring
Spacer
Flat Washer
Wave Washer
Note • Do not remove the flat washer and wave washer.

Zebra 110XiIII Plus Series Specifications

General

Brand	Zebra
Model	110XiIII Plus Series
Category	Printer
Language	English