viii 110XiIIIPlus Maintenance Manual 13185L-002 Rev. A 1/24/06
Table of Contents
Reconnect Printer......................................................................................... 4-15
Remove Power Supply................................................................................. 4-17
Install the Power Supply .............................................................................. 4-18
Remove the Main Logic Board.................................................................... 4-19
Install the Main Logic Board ....................................................................... 4-22
Adjust the Tension ....................................................................................... 4-23
Remove the Main Drive Belt ....................................................................... 4-25
Install Main Drive Belt ................................................................................ 4-25
Remove the Rewind Drive Belt ................................................................... 4-28
Install the Rewind Drive Belt ...................................................................... 4-29
Remove and Install the Printhead ............................................................................ 4-29
Remove the Printhead.................................................................................. 4-29
Install the Printhead ..................................................................................... 4-30
Adjust Printhead ...................................................................................................... 4-32
Toggle Pressure............................................................................................ 4-33
Printhead Position ........................................................................................ 4-34
Adjust the Wear Plate (Balance) Position................................................................ 4-36
Test Printhead Parallelism ....................................................................................... 4-37
Adjust Printhead Parallelism ....................................................................... 4-37
Adjust the Strip Plate ............................................................................................... 4-38
Adjust Darkness....................................................................................................... 4-38
Align the Take-Label (Label-Available) Sensor ..................................................... 4-39
Adjust the Media Tracking ...................................................................................... 4-40
Rewind Mode............................................................................................... 4-40
Peel-Off Mode ............................................................................................. 4-41
Adjust and Maintain Spindle ................................................................................... 4-42
Tension Measurement Procedure................................................................. 4-43
Adjust the Spindle Tension.......................................................................... 4-43
Spindle Maintenance.................................................................................... 4-43
Replace the Platen Roller......................................................................................... 4-44
Remove the Upper Platen Roller ................................................................. 4-44
Install the Upper Platen Roller..................................................................... 4-45
Remove and Install the Rewind (Lower) Platen Roller........................................... 4-46
Remove the Rewind Platen Roller............................................................... 4-46
To Next Page
Loading...
Need help?
General
