Zebra DS8108

A - 2 DS8108 Digital Scanner Product Reference Guide
USB FN1 Substitution N/A N/A Disable 4-13
Function Key Mapping N/A N/A Disable 4-14
Simulated Caps Lock N/A N/A Disable 4-14
Convert Case N/A N/A None 4-15
USB Static CDC N/A N/A Enable 4-15
TGCS (IBM) USB Beep Directive N/A N/A Ignore 4-16
TGCS (IBM) USB Bar Code
Configuration Directive
N/A N/A Ignore 4-16
TGCS (IBM) USB Specification
Version
N/A N/A Version 2.2 4-17
SSI Host Parameters
Select SSI Host N/A N/A N/A 5-12
Baud Rate 156 9Ch 9600 5-12
Parity 158 9Eh None 5-14
Check Parity 151 97h Disable 5-15
Stop Bits 157 9Dh 1 5-15
Software Handshaking 159 9Fh ACK/NAK 5-16
Host RTS Line State 154 9Ah Low 5-17
Decode Data Packet Format 238 EEh Send Raw Decode Data 5-17
Host Serial Response Timeout 155 9Bh 2 Seconds 5-18
Host Character Timeout 239 EFh 200 msec 5-19
Multipacket Option 334 F0h 4Eh Option 1 5-20
Interpacket Delay 335 F0h 4Fh 0 msec 5-21
Event Reporting
Decode Event 256 F0h 00h Disable 5-22
Boot Up Event 258 F0h 02h Disable 5-23
Parameter Event 259 F0h 03h Disable 5-23
Table A-1 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.