Zebra DS8108

A - 10 DS8108 Digital Scanner Product Reference Guide
Codabar (NW - 7)
Codabar 7 07h Enable 11-59
Set Lengths for Codabar 24, 25 18h, 19h 4 to 55 11-59
CLSI Editing 54 36h Disable 11-61
NOTIS Editing 55 37h Disable 11-61
Codabar Upper or Lower Case Start/
Stop Characters Detection
855 F2h 57h Upper Case 11-62
MSI
MSI 11 0Bh Disable 11-63
Set Length(s) for MSI 30, 31 1Eh, 1Fh 4 to 55 11-63
MSI Check Digits 50 32h One 11-65
Transmit MSI Check Digit 46 2Eh Disable 11-65
MSI Check Digit Algorithm 51 33h Mod 10/Mod 10 11-66
MSI Reduced Quiet Zone 1392 F8h 05h 70h Disable 11-66
Chinese 2 of 5
Chinese 2 of 5 408 F0h 98h Disable 11-67
Matrix 2 of 5
Matrix 2 of 5 618 F1h 6Ah Disable 11-68
Matrix 2 of 5 Lengths 619
620
F1h 6Bh
F1h 6Ch
4 to 55 11-68
Matrix 2 of 5 Check Digit 622 F1h 6Eh Disable 11-70
Transmit Matrix 2 of 5 Check Digit 623 F1h 6Fh Disable 11-70
Korean 3 of 5
Korean 3 of 5 581 F1h 45h Disable 11-71
Inverse 1D 586 F1h 4Ah Regular 11-72
GS1 DataBar 11-73
GS1 DataBar Omnidirectional 338 F0h 52h Enable 11-73
GS1 DataBar Limited 339 F0h 53h Enable 11-73
Table A-1 Parameter Defaults (Continued)
Parameter
Parameter
Number
1
SSI
Number
2
Default
Page
Number
1. Parameter number decimal values are used for programming via RSM commands.
2. SSI number hex values are used for programming via SSI commands.