ZyXEL Communications NR/FWA Outdoor Series - Page 125

Chapter 9 Home Networking
NR/FWA Outdoor Series User’s Guide
125
Figure 80 Network Setting > Home Networking > LAN Setup (continued)
The following table describes the fields in this screen.
Table 39 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
Interface Group
Group Name Select the interface group that you want to configure its LAN settings.
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your Zyxel Device in dotted decimal notation,
for example, (factory default).
Subnet Mask Enter the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Zyxel Device automatically computes the subnet mask
based on the IP address you enter, so do not change this field unless you are instructed to
do so.
DHCP Server State
DHCP Select Enable to have your Zyxel Device assign IP addresses, an IP default gateway and DNS
servers to LAN computers and other devices that are DHCP clients.
If you select Disable, you need to manually configure the IP addresses of the computers and
other devices on your LAN.
If you select DHCP Relay, the Zyxel Device acts as a surrogate DHCP server and relays DHCP
requests and responses between the remote server and the clients.
DHCP Relay Server Address
This field is only available when you select DHCP Relay in the DHCP field.
IP Address Enter the IPv4 IP address of the actual remote DHCP server in this field.