ZyXEL Communications NR/FWA Outdoor Series - Edit Agent

Chapter 28 TR-369
NR/FWA Outdoor Series User’s Guide
249
28.4.1 Edit Agent
Click the Edit icon next to an agent in Maintenance > TR-369 Local Agent > Agent. Use this screen to
configure the required information that the Zyxel Device agent needs to communicate with a controller.
Figure 168 Maintenance > TR-369 Local Agent > Agent: Edit
The following table describes the fields in this screen.
Enable This displays if the Zyxel Device is enabled as an agent.
Alias This is a friendly name for the Zyxel Device.
Protocol The Zyxel Device supports the MQ Telemetry Transport (MQTT) protocol to send messages.
Response Topic This displays the topic name for the Zyxel Device to receive USP messages.
Reference This displays the MQTT client you configured in the MQTT screen. For example,
Device.MQTT.Client.1.
Modify Click the Edit icon to configure an entry.
OK Click OK to save your changes.
Cancel Click Cancel to restore the screen’s last saved settings.
Table 106 Maintenance > TR-369 Local Agent > Agent (continued)
LABEL DESCRIPTION
Table 107 Maintenance > TR-369 Local Agent > Agent: Edit
LABEL DESCRIPTION
Enable Slide this to the right to enable the Zyxel Device as a TR-369 agent.
Alias Enter a unique name to identify the Zyxel Device acting as an agent to the controller. Please
note the following:
• The value must not be empty.
• The value must start with a letter.
• If the value is not assigned by the controller at creation time, you must assign a value with a
"cpe-" prefix.
• If the value is not assigned by the controller on creation, you must choose an initial value that
doesn't conflict with any existing entries.
Protocol At the time of writing, just the MQ Telemetry Transport (MQTT) protocol is used by the Zyxel
Deviceto send messages.