Chapter 9 Home Networking
NR/FWA Outdoor Series User’s Guide
128
9.3 Static DHCP
When any of the LAN clients in your network want an assigned fixed IP address, add a static lease for
each LAN client. Knowing the LAN client’s MAC addresses is necessary. This table allows you to assign IP
addresses on the LAN to individual computers based on their MAC addresses.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is assigned
at the factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02.
IPv6 Start Address This field specifies the first of the contiguous addresses in the IPv6 address pool.
IPv6 End Address This field specifies the last of the contiguous addresses in the IPv6 address pool.
IPv6 Domain Name The field specifies the domain name of the IPv6 address.
Client IAPD Setup
IAPD Enable Identity Association for Prefix Delegation (IAPD) is an IPv6 prefix set assigned to a requesting
device. Each IAPD identifies an interface configured by DHCPv6. A device may have more
than one IAPD due to multiple interfaces.
Click this to enable and configure the following fields.
IPv6 Prefix Enter the IPv6 prefix assigned by the DHCPv6 server.
IPv6 Address Enter the IPv6 address assigned by the DHCPv6 server.
IPv6 DNS Values
IPv6 DNS Server 1 – 3 Specify the IP addresses up to three DNS servers for the DHCP clients to use. Use one of the
following ways to specify these IP addresses.
User Defined – Select this if you have the IPv6 address of a DNS server. Enter the DNS server
IPv6 addresses the Zyxel Device passes to the DHCP clients.
From ISP – Select this if your ISP dynamically assigns IPv6 DNS server information.
Proxy – Select this if the DHCP clients use the IP address of this interface and the Zyxel Device
works as a DNS relay.
Otherwise, select None if you do not want to configure IPv6 DNS servers.
DNS Query Scenario Select how the Zyxel Device handles clients’ DNS information requests.
IPv4/IPv6 DNS Server: The Zyxel Device forwards the requests to both the IPv4 and IPv6 DNS
servers and sends clients the first DNS information it receives.
IPv6 DNS Server Only: The Zyxel Device forwards the requests to the IPv6 DNS server and
sends clients the DNS information it receives.
IPv4 DNS Server Only: The Zyxel Device forwards the requests to the IPv4 DNS server and
sends clients the DNS information it receives.
IPv6 DNS Server First: The Zyxel Device forwards the requests to the IPv6 DNS server first and
then the IPv4 DNS server. Then it sends clients the first DNS information it receives.
IPv4 DNS Server First: The Zyxel Device forwards the requests to the IPv4 DNS server first and
then the IPv6 DNS server. Then it sends clients the first DNS information it receives.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
Table 39 Network Setting > Home Networking > LAN Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
