ZyXEL Communications NR/FWA Outdoor Series - Access Control (Rules); Add Customized Service

Chapter 15 Firewall
NR/FWA Outdoor Series User’s Guide
186
15.4.1 Add Customized Service
Add a customized rule or edit an existing rule by specifying the protocol and the port numbers. Click
Add New Protocol Entry in the Protocol screen to display the following screen.
Figure 130 Security > Firewall > Protocol: Add New Protocol Entry
The following table describes the labels in this screen.
15.5 Access Control (Rules)
An Access Control List (ACL) rule is a manually-defined rule that can accept, reject, or drop incoming or
outgoing packets from your network. This screen displays a list of the configured incoming or outgoing
filtering rules. Note the order in which the rules are listed. Click Security > Firewall > Access Control to
display the following screen.
Ports/Protocol Number This shows the port number or range and the IP protocol (TCP or UDP) that defines
your customized service.
Modify Click this to edit a customized service.
Table 71 Security > Firewall > Protocol (continued)
LABEL DESCRIPTION
Table 72 Security > Firewall > Protocol: Add New Protocol Entry
LABEL DESCRIPTION
Service Name Enter a descriptive name for your customized service. You can use up to 16 printable
characters except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
Description Enter a description for your customized service. You can use up to 16 printable characters
except [ " ], [ ` ], [ ' ], [ < ], [ > ], [ ^ ], [ $ ], [ | ], [ & ], or [ ; ]. Spaces are allowed.
Protocol Select the protocol (TCP, UDP, ICMP, ICMPv6, or Other) that defines your customized port from
the drop down list box.
Protocol Number Enter a single port number or the range of port numbers (0 – 255) that define your customized
service.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving.