Chapter 28 TR-369
NR/FWA Outdoor Series User’s Guide
246
28.3.1 Add or Edit MQTT
Click Add New in the MQTT screen or click the Edit icon next to a controller. Use this screen to configure
the required information for the MQTT broker.
Figure 166 Maintenance > TR-369 Local Agent > MQTT: Add or Edit
The following table describes the fields in this screen.
Enable This displays if the MQTT client is enabled.
Broker Address This displays the URL of the MQTT broker.
Broker Port This displays the port used for registration with the broker.
Transport
Protocol
This displays the transport protocol (TCP/IP or TLS) for the Zyxel Device to send messages to the
broker.
Alias This displays a friendly name to identify the MQTT client.
QoS This displays the Quality of Service transmission between the Zyxel Device and the broker.
Client ID This field displays the unique Client ID of the client connecting to the MQTT broker.
Modify Click the Edit icon to configure an entry.
Click the Delete icon to remove an entry.
Table 104 Maintenance > TR-369 Local Agent > MQTT (continued)
LABEL DESCRIPTION
Table 105 Maintenance > TR-369 Local Agent > MQTT: Add or Edit
LABEL DESCRIPTION
Enable Slide this to the right to enable this MQTT client.
Broker Address Enter the URL of the MQTT broker. Make sure the broker is reachable from the Zyxel Device.
Broker Port Enter the port used for registration with the broker. The default port is shown here. If the broker is
using a different port, enter that port number here.
To Next Page
Loading...
