Chapter 7 Broadband
NR/FWA Outdoor Series User’s Guide
95
7.11 Cellular Lock (5G)
Use this screen to configure cellular lock on Zyxel Devices that use NR (5G) connections.
To lock a base station identified by its Physical Cell ID and band, go to Network Setting > Broadband >
Cellular Lock (5G).
Note: Enabling/Disabling Cellular Lock will cause a temporary WAN disconnection.
Note: NR (5G) Cellular Lock only works when the Zyxel Device is using the NR5G-SA mode.
Make sure the Preferred Access Technology on the Network Setting > Broadband >
Cellular Band screen is set to NR5G-SA or NR5G-SA/NR5G-NSA/5G (Auto Switch).
ACT This shows the Access Technology (ACT) of the cell.
MNC This shows the Mobile Network Code (MNC). MNC is a unique code that identifies a
Public Land Mobile Network (PLMN) in a country. MCC and MNC combined together
are used to identify a globally unique PLMN.
MCC This shows the Mobile Country Code (MCC). MCC is a unique code that identifies the
country where a Public Land Mobile Network (PLMN) is at.
PhyCellID This shows the PCI of a cell. Use this to enter the PCI number of the base station you
choose to connect to.
RFCN This shows the RFCN (Radio Frequency Channel Number) of a cell signal. Use this to
enter the RFCN of the base station you choose to connect to. See Section on page 69
for more information.
RSRP This shows the RSRP value of a signal which helps you choose a network with higher
quality. See Section on page 69 for more information.
RSRQ This shows the RSRQ value of a signal which helps you choose a network with higher
quality. See Section on page 70 for more information.
Table 27 Network Setting > Broadband > Cellular Lock (LTE) (continued)
LABEL DESCRIPTION
To Next Page
Loading...
