Chapter 7 Broadband
NR/FWA Outdoor Series User’s Guide
96
Figure 63 Network Setting > Broadband > Cellular Lock (5G)
The following table describes the fields in this screen.
Table 28 Network Setting > Broadband > Cellular Lock (5G)
LABEL DESCRIPTION
NR(5G) Lock Management
PCI_Enable Slide this to the right to enable PCI (Physical Cell Identifier) Lock on a base station when
the Zyxel Device has a NR (5G) connection.
Band Enter the band number to which you choose to connect.
Note: Make sure to select the same band in the Network Setting > Broadband
> Cellular Band screen so as the Zyxel Device can connect to that
band.
PCI Use this to enter the PCI number of the base station you want the Zyxel Device to
connect to (0 – 504).
RFCN Enter the RFCN (Radio Frequency Channel Number) for the NR (5G) frequency of the
specified PCI (1 – 65535).
SCS Select the Subcarrier Spacing (SCS) from the drop-down list. Subcarriers are small signal
carriers that divide a frequency channel, which is the main carrier wave. Subcarrier
spacing is the space between each subcarrier. At the time of writing, SCS ranges from
15-120 KHz.You should select the same SCS that is used by the ISP.
To Next Page
Loading...
