ZyXEL Communications NR/FWA Outdoor Series - Page 248

Chapter 28 TR-369
NR/FWA Outdoor Series User’s Guide
248
Figure 167 Maintenance > TR-369 Local Agent > Agent
The following table describes the fields in this screen.
Table 106 Maintenance > TR-369 Local Agent > Agent
LABEL DESCRIPTION
Endpoint ID This identifies the Zyxel Device acting as an agent.
The Endpoint Identifier (ID) is used in the USP Record and various Parameters in a USP Message to
uniquely identify agent endpoints. It can be globally or locally unique, either among all
endpoints or among all controllers or all agents, depending on the scheme used for assignment.
It has two mandatory and one optional components: authority-scheme, authority-id, and
instance-id.
These three components are combined as: authority-scheme ":" [authority-id] ":" instance-id
The format of the authority-id is dictated by the authority-scheme. The format of the instance-id
is dictated either by the authority-scheme or by the entity identified by the authority-id.
When used in a certificate, an Endpoint ID is expressed as a urn in the bbf namespace as:
"urn:bbf:usp:id:" authority-scheme ":" [authority-id] ":" instance-id
When used anywhere else (e.g. in the to_id and from_id of a USP Record), the namespace
information is omitted, and the Endpoint ID is expressed as: authority-scheme ":" [authority-id] ":"
instance-id.
WAN Interface
Used by TR-369
Agent
Select Any WAN to have the Zyxel Device use any cellular WAN that is available (the APN you
enabled in Network Setting > Broadband > Cellular APN) to send TR-369 messages.
Select Multiple WAN and then choose a specific WAN that you configured in Network Setting >
Broadband > Cellular APN to send TR-369 messages.
MTP The Message Transfer Protocol (MTP) is the protocol that carries a message.
Add New At the time of writing, you can only have one agent MTP entry, so you can only edit the existing
entry.
# This displays the index number of the MTP (Message Transfer Protocol).