Chapter 6 Connection Status
NR/FWA Outdoor Series User’s Guide
68
Data Roaming This displays if data roaming is enabled on the Zyxel Device.
Data roaming is to use your Zyxel Device in an area which is not covered by your service
provider. Enable roaming to ensure that your Zyxel Device is kept connected to the Internet
when you are traveling outside the geographical coverage area of the network to which you
are registered.
Operator This displays the name of the service provider.
PLMN This displays the PLMN (Public Land Mobile Network) number.
GNSS Information
Global Navigation Satellite System (GNSS) sends position and timing data from high orbit artificial satellites. It works
with GPS navigational satellites to provide better receiver accuracy and reliability than just using GPS alone. This is
necessary for 5G networks that require very accurate timing for time and frequency synchronization. With GNSS,
your can easily locate the Zyxel Device with accurate information.
Note: Not all models support the GNSS feature.
Enable This shows if GNSS is enabled.
Note: This can only be configured by a qualified service technician.
Scan
OnBoot
This shows Enable if Scan OnBoot is enabled, so that GNSS runs automatically after the Zyxel
Device is turned on.
Note: This can only be configured by a qualified service technician.
Scan Status This shows GNSS error codes for debugging by a qualified service technician.
HDOP Horizontal Dilution of Precision (HDOP) shows how accurate data collected by the Zyxel Device
is according to the current satellite configuration. A smaller value of HDOP means a higher
precision.
Display
Format
This shows the latitude and longitude display modes. There are three modes: 0, 1, and 2.
Below are examples for these modes shown in latitude/longitude.
0 – ddmm.mmmmN/S, dddmm.mmmmE/W
1 – ddmm.mmmmmm, N/S, dddmm.mmmmmm, E/W
2 – (–)dd.ddddd, (–)ddd.ddddd
N/S/E/W: North/South/East/West
“–” : Negative values refer to South latitude/West longitude respectively. Positive values refer to
North latitude/East longitude.
Latitude This shows the latitude coordinate of the Zyxel Device. These positioning values (latitude,
longitude, and altitude) help you locate the Zyxel Device accurately.
Longitude This shows the longitude coordinate of the Zyxel Device.
Elevation This shows the altitude of the Zyxel Device above sea level in meters.
Positioning
Mode
This shows the GNSS positioning mode. 2D (“2”) GNSS positioning mode displays latitude and
longitude co-ordinates; 3D (“2”) GNSS positioning mode displays latitude and longitude co-
ordinates, and elevation.
Course over
ground
This shows the course of the Zyxel Device based on true North. Course Over Ground (COG) is
different from the direction an object is headed, but the path derived from its actual motion
(considered as Track), since the motion of an object is often with respect to other factors like
wind and tides.
Speed Over
Ground
This shows the Speed Over Ground (SOG) of the Zyxel Device. SOG is the true object speed over
the surface of the Earth.
Last Fix Time This shows the last time in UTC format that the position of the Zyxel Device was updated.
Table 12 Cellular Info: Detailed Information (continued)
LABEL DESCRIPTION
To Next Page
Loading...
