ZyXEL Communications NR/FWA Outdoor Series - Page 73

Chapter 6 Connection Status
NR/FWA Outdoor Series User’s Guide
73
Figure 44 LAN Setup
Each field is described in the following table.
Table 14 LAN Setup
LABEL DESCRIPTION
Group Name Select the interface group you want to use. Usually Default.
LAN IP Setup
IP Address Enter the LAN IPv4 IP address you want to assign to your Zyxel Device in dotted decimal
notation, for example, (factory default).
Subnet Mask Enter the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your Zyxel Device automatically computes the subnet mask
based on the IP Address you enter, so do not change this field unless you are instructed to
do so.
IP Addressing Values
Beginning IP
Address
This field specifies the first of the contiguous addresses in the IP address pool.
Ending IP
Address
This field specifies the last of the contiguous addresses in the IP address pool.
DHCP Server Lease
Time
This is the period of time DHCP-assigned addresses is used. DHCP automatically assigns IP
addresses to clients when they log in. DHCP centralizes IP address management on central
computers that run the DHCP server program. DHCP leases addresses, for a period of time,
which means that past addresses are “recycled” and made available for future
reassignment to other systems.
Days/Hours/
Minutes
Enter the lease time of the DHCP server.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.