ZyXEL Communications NR/FWA Outdoor Series - Page 77

Chapter 7 Broadband
NR/FWA Outdoor Series User’s Guide
77
Figure 48 Network Setting > Broadband (with IPv4 and IPv6 Default Gateway)
Figure 49 Network Setting > Broadband (with MLD Proxy)
The following table describes the labels in this screen.
Table 16 Network Setting > Broadband
LABEL DESCRIPTION
# This is the index number of the entry.
Name This is the service name of the connection.
Type This shows whether it is a cellular or Ethernet connection.
Mode This shows the connection is in routing mode.
Encapsulation This is the method of encapsulation used by this connection.
802.1p This indicates the 802.1p priority level assigned to traffic sent through this connection. This
displays N/A when there is no priority level assigned.
802.1q This indicates the VLAN ID number assigned to traffic sent through this connection. This displays
N/A when there is no VLAN ID number assigned.
IGMP Proxy This shows whether the Zyxel Device act as an IGMP proxy on this connection.
NAT This shows whether NAT is activated or not for this connection.
Default
Gateway
This shows whether the Zyxel Device use the WAN interface of this connection as its default
gateway.
IPv4 Default
Gateway
This shows whether the Zyxel Device use the WAN interface of this connection as its IPv4 default
gateway.
IPv6 Default
Gateway
This shows whether the Zyxel Device use the WAN interface of this connection as its IPv6 default
gateway.
IPv6 This shows whether IPv6 is activated or not for this connection. IPv6 is not available when the
connection uses the IP Passthrough (bridging) service.
MLD Proxy This shows whether Multicast Listener Discovery (MLD) is activated or not for this connection. MLD
is not available when the connection uses the bridging service.
Modify Click the Edit icon ( ) to configure the WAN connection.