ZyXEL Communications USG FLEX H Series - Page 170

Chapter 11 IPSec VPN
USG FLEX H Series User’s Guide
170
11.3.1.2 Network
Use this screen to configure the Zyxel Device interface and remote IPSec device settings.
Figure 122 VPN > Site to Site VPN > Add/Edit > Network
Each field is described in the following table.
11.3.1.3 Authentication
Use this screen to configure the authentication type and settings.
Table 87 VPN > Site-to-Site VPN > Add/Edit > Network
LABEL DESCRIPTION
My Address Enter the IPv4 address or domain name of the interface the VPN connection uses to
transmit packets on the Zyxel Device.
Peer Gateway Address Enter the WAN IPv4 address or domain name of the remote IPSec device to identify the
remote IPSec router by its IP address or domain name.