ZyXEL Communications USG FLEX H Series - Page 210

Chapter 14 Object
USG FLEX H Series User’s Guide
210
Figure 143 Object > Address > Address > Add/Edit
The following table describes the labels in this screen.
Table 106 Object > Address > Address > Add/Edit
LABEL DESCRIPTION
Name Type the name used to refer to the address. You may use 2-30 single-byte characters, including
0-9a-zA-Z, underscores(
_), or dashes (-), but the first character cannot be a number. This value
is case-sensitive.
Description Enter the description associated with the zone, if any. You can use 1 to 30 single-byte
characters, including 0-9a-zA-Z. Special characters are not allowed
Address Type Select the type of address you want to create.
Note: The Zyxel Device automatically updates address objects that are based on an
interface’s IP address, subnet, or gateway if the interface’s IP address settings
change. For example, if you change 1’s IP address, the Zyxel Device
automatically updates the corresponding interface-based, LAN subnet
address object.
IP Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter the IP
address that this address object represents.
Starting IP
Address
This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the
beginning of the range of IP addresses that this address object represents.
Ending IP Address This field is only available if the Address Type is RANGE. This field cannot be blank. Enter the end
of the range of IP address that this address object represents.
Network This field is only available if the Address Type is CIDR, in which case this field cannot be blank.
Enter the IP address of the network that this address object represents.
Netmask This field is only available if the Address Type is CIDR, in which case this field cannot be blank.
Enter the subnet mask of the network that this address object represents. Use dotted decimal
format.
Interface If you selected INTERFACE IP, INTERFACE SUBNET, or INTERFACE GATEWAY as the Address Type,
use this field to select the interface of the network that this address object represents.
Region If you selected GEOGRAPHY as the Address Type, use this field to select a country or continent.
A GEOGRAPHY object uses the data from the country-to-IP/continent-to-IP address database.
Go to the Object > Address > Geo IP screen to configure the custom country-to-IP/continent-
to-IP address mappings for a GEOGRAPHY object.