Chapter 14 Object
USG FLEX H Series User’s Guide
209
Figure 142 Object > Address > Address
The following table describes the labels in this screen. See Section 14.1.2.1 on page 209 for more
information as well.
14.1.2.1 IPv4 Address Add/Edit Screen
The Object > Address > Address > Add/Edit screen allows you to create a new address or edit an
existing one. To access this screen, go to the Address screen (see
Section 14.1.2 on page 208), and click
either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Table 105 Object > Address > Address
LABEL DESCRIPTION
IPv4 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
Reference Select an entry and click Reference to check which settings use the entry.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses the
settings of one of the Zyxel Device’s interfaces.
Address This field displays the IPv4 addresses represented by each address object. If the object’s
settings are based on one of the Zyxel Device’s interfaces, the name of the interface displays
first followed by the object’s current address settings.
Reference This displays the number of times an object reference is used in a profile.
To Next Page
Loading...
