ZyXEL Communications USG FLEX H Series - Page 229

Chapter 14 Object
USG FLEX H Series User’s Guide
229
14.4.2.2 The Recurring Schedule Add/Edit Screen
The Recurring Schedule Add/Edit screen allows you to define a recurring schedule or edit an existing
one. To access this screen, go to the Schedule screen (see
Section 14.4.2 on page 226), and click either
the Add icon or an Edit icon in the Recurring section.
Figure 158 Object > Schedule > Edit (Recurring)
The Year, Month, and Day columns are not used in recurring schedules and are disabled in this screen.
The following table describes the remaining labels in this screen.
Table 119 Object > Schedule > Edit (Recurring)
LABEL DESCRIPTION
Configuration
Name Type the name used to refer to the recurring schedule. You may use 2-30 single-byte
characters, including 0-9a-zA-Z, underscores(
_), or dashes (-), but the first character cannot be
a number. This value is case-sensitive.
Description Type a description used to identify the one-time schedule. You may use 1-30 single-byte
characters, including 0-9a-zA-Z’()+,/:=?;!*#@$_%-”
Date Time
StartTime Specify the hour and minute when the schedule begins each day. Then, select each day of
the week the recurring schedule is effective.
• Hour - 1-12 AM/PM
• Minute - 0 - 59
StopTime Specify the hour and minute when the schedule ends each day. Then, select each day of the
week the recurring schedule is effective.
• Hour - 1-12 AM/PM
• Minute - 0 - 59
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to return the screen to its last-saved settings.