ZyXEL Communications USG FLEX H Series - Page 397

Chapter 25 Log and Report
USG FLEX H Series User’s Guide
397
Figure 244 SecuReporter Application Scenario
How to activate and enable SecuReporter
1 If SecuReporter Service Status does not display Activated, you have to log in to NCC and activate the
SecuReporter license for this Zyxel Device. The Zyxel Device must be able to communicate with the NCC
server.
2 After the SecuReporter license is activated, go back to the Log & Report > SecuReporter screen, and
select the categories of logs that you want this Zyxel Device to send to the SecuReporter portal.
3 Slide the switch to the right under General Settings to enabled SecuReporter. Do not go to the
SecuReporter portal until after you have enabled SecuReporter on this Zyxel Device and applied the
settings. You can also see license status, type, expiration date.
4 Click Apply and wait.