ZyXEL Communications USG FLEX H Series - Page 46

Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User’s Guide
46
Figure 35 USG FLEX 700H Front Panel
The following table describes the front panel LEDs.
Table 16 LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR/SYS Green Off The Zyxel Device is not ready or has failed.
On The Zyxel Device is ready and running.
Blinking The Zyxel Device is booting or upgrading firmware
Red On The Zyxel Device has an error or has failed.
Blinking The Zyxel Device is returning to factory defaults.
USER Green On There are accounts with User Type set as admin logged into the Zyxel
Device.
Blinking New firmware is available or your license has expired.
Amber On There are IP addresses locked out of the Zyxel Device.
Off USER LED is not enabled in System > Settings.
PoE (PoE1/PoE2) Green On The PoE connected to this port is in AT mode (PoE AT enabled).
Amber On The PoE connected to this port is in AF mode (PoE AF enabled)
Off No PoE is connected to this port (PoE disabled).
P1-P8 (USG FLEX
100H, USG FLEX
100HP)
P3-P8 (USG
FLEX200, USG
FLEX 200HP)
P5-P12 (USG FLEX
500H, USG FLEX
700H)
Amber On This port has a successful 10/100 Mbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 10/100
Mbps.
Green On This port has a successful 1 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 1 Gbps.
Off There is no connection on this port.
P1, P2 (USG FLEX
200, USG FLEX
200HP)
P1-P4 (USG FLEX
500H)
Sky Blue On This port has a successful 2.5 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 2.5 Gbps.
Green On This port has a successful 1 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 1 Gbps.
Amber On This port has a successful 100 Mbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 100
Mbps.
Off There is no connection on this port.