Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User’s Guide
47
The following table describes the ports on the front panel.
P3, P4 (USG FLEX
700H)
Blue On This port has a successful 10 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 10 Gbps.
Purple On This port has a successful 5 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 5 Gbps.
Sky Blue On This port has a successful 2.5 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 2.5 Gbps.
Green On This port has a successful 1 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 1 Gbps.
Amber On This port has a successful 100 Mbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 100
Mbps.
Off There is no connection on this port.
P13, P14 SPF+
(USF FLEX 700H)
Blue On This port has a successful 10 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 10 Gbps.
Green On This port has a successful 1 Gbps link.
Blinking The Zyxel Device is sending or receiving packets on this port at 1 Gbps.
Off There is no connection on this port.
Table 17 Front Panel Ports
LABEL DESCRIPTION
REBOOT Press the button for about 5 seconds to reboot the Zyxel Device.
RESET Press the button in for about 7 seconds (or until the PWR/SYS LED starts to blink), then release it
to return the Zyxel Device to the default configuration (password is 1234, LAN IP address
192.168.168.1 and so on).
Press the button in for more than 30 seconds, then release it to return the Zyxel Device to
factory defaults. The Zyxel Device PWR/SYS LED will blink green while booting up.
USB Connect a storage device for system logs and storage.
P1-P8 (USG FLEX
200H/USG FLEX
200HP)
P1-P12 (USG FLEX
500H/USG FLEX
700H)
These are 1G/2.5G/10G RJ-45 Ethernet ports.
P13-P14 (USG
FLEX 700H)
These are 10G SFP+ ports.
CONSOLE (Cisco
Like pin define)
You can use the console port to manage the Zyxel Device using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
•Parity None
•Stop Bit 1
• Flow Control Off
Table 16 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
