Chapter 42 Object
ZyWALL/USG Series User’s Guide
767
The following table describes the labels in this screen. See Section 42.6.2.1 on page 767 for more
information as well.
42.6.2.1 IPv4 Address Add/Edit Screen
The Configuration > IPv4 Address Add/Edit screen allows you to create a new address or edit
an existing one. To access this screen, go to the Address screen (see Section 42.6.2 on page 766),
and click either the Add icon or an Edit icon in the IPv4 Address Configuration section.
Figure 525 IPv4 Address Configuration > Add/Edit
Table 307 Configuration > Object > Address/Geo IP > Address
LABEL DESCRIPTION
IPv4 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that shows which settings
use the entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses
the settings of one of the ZyWALL/USG’s interfaces.
IPv4 Address This field displays the IPv4 addresses represented by each address object. If the object’s
settings are based on one of the ZyWALL/USG’s interfaces, the name of the interface
displays first followed by the object’s current address settings.
Reference This displays the number of times an object reference is used in a profile.
IPv6 Address Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so.
Object
References
Select an entry and click Object References to open a screen that shows which settings
use the entry.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses
the settings of one of the ZyWALL/USG’s interfaces.
IPv6 Address This field displays the IPv6 addresses represented by each address object. If the object’s
settings are based on one of the ZyWALL/USG’s interfaces, the name of the interface
displays first followed by the object’s current address settings.
To Next Page
Loading...
