ZyXEL Communications XGS4600 Series - Page 337

Chapter 31 VLAN Mapping
XGS4600 Series User’s Guide
337
Figure 266 Advanced Application > VLAN Mapping > VLAN Mapping Configuration (Stacking Mode)
The following table describes the labels in this screen.
Table 145 Advanced Application > VLAN Mapping > VLAN Mapping Configuration
LABEL DESCRIPTION
Active Check this box to activate this rule.
Name Enter a descriptive name (up to 32 printable ASCII characters) for identification purposes.
Port Type a port to be included in this rule. In stacking mode, the first field is the slot ID and the
second field is the port number.
VID Enter a VLAN ID from 1 to 4094. This is the VLAN tag carried in the packets and will be translated
into the VID you specified in the Translated VID field.
Translated VID Enter a VLAN ID (from 1 to 4094) into which the customer VID carried in the packets will be
translated.
Priority Select a priority level (from 0 to 7). This is the priority level that replaces the customer priority
level in the tagged packets or adds to the untagged packets.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This is the number of the VLAN mapping entry in the table. Click on an index number to change
the settings.
Active This shows whether this entry is activated or not.
Name This is the descriptive name for this rule.
Port This is the port number to which this rule is applied.
VID This is the customer VLAN ID in the incoming packets.
Translated VID This is the VLAN ID that replaces the customer VLAN ID in the tagged packets.
Priority This is the priority level that replaces the customer priority level in the tagged packets.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove in the Delete column and then click the Delete
button.
Cancel Click Cancel to clear the Delete check boxes.