Chapter 13 Spanning Tree Protocol
XGS4600 Series User’s Guide
159
The following table describes the labels in this screen.
13.4 Rapid Spanning Tree Protocol Status
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Advanced Application > Spanning Tree Protocol in the navigation
panel to display the status screen as shown next. See Section 13.1 on page 155 for more information on
RSTP.
Note: This screen is only available after you activate RSTP on the Switch.
Figure 128 Advanced Application > Spanning Tree Protocol (Standalone Mode)
Figure 129 Advanced Application > Spanning Tree Protocol (Stacking Mode)
Table 59 Advanced Application > Spanning Tree Protocol > Configuration
LABEL DESCRIPTION
Spanning Tree
Mode
You can activate one of the STP modes on the Switch.
Select Rapid Spanning Tree, Multiple Rapid Spanning Tree or Multiple Spanning Tree.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
