Chapter 8 Basic Setting
XGS4600 Series User’s Guide
100
The following table describes the labels in this screen.
8.9 IPv6
Use this screen to view the IPv6 interface status and configure the Switch’s management IPv6 addresses.
8.9.1 IPv6 Status
Click Basic Setting > IPv6 in the navigation panel to display the IPv6 status screen as shown next.
Figure 76 Basic Setting > IPv6
Table 23 Basic Setting > Interface Setup
LABEL DESCRIPTION
Interface Type Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Interface ID Specify a unique identification number (from 1 to 4094) for the VLAN interface or a unique
identification number (from 0 to 2) for the loopback interface.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
Advanced Application > VLAN screens.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the Save link on the top navigation panel to save your changes
to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Index This field displays the index number of an entry.
Interface Type This field displays the type of interface.
Interface ID This field displays the identification number of the interface.
Interface This field displays the interface’s descriptive name which is generated automatically by the
Switch. The name is from a combination of the interface type and ID number.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
To Next Page
Loading...
