ZyXEL Communications XGS4600 Series - Ipv6 Source Guard Port Setup

Chapter 29 ARP Inspection
XGS4600 Series User’s Guide
323
29.7 IPv6 Source Guard Port Setup
Use this screen to apply configured IPv6 source guard policies to ports you specify. Use port * to apply a
policy to all ports. To open this screen, click Advanced Application > IP Source Guard > IPv6 Source
Guard Port Setup.
Figure 249 Advanced Application > IP Source Guard > IPv6 Source Guard Port Setup (Standalone
Mode)
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select an entry check box and click Delete to remove the specified entry.
Cancel Click this to clear the Delete check boxes above.
Table 138 Advanced Application > IP Source Guard > IPv6 Source Guard Policy Setup (continued)
LABEL DESCRIPTION