Chapter 71 Port Status
XGS4600 Series User’s Guide
600
71.3.4 Port Utilization
This screen displays the percentage of actual transmitted or received frames on a port as a percentage
of the Link speed. To view port utilization, click Management > Port Status > Port Utilization to see the
following screen. Alternatively, click Status from any Web Configurator screen and then the Port Status
link in the Quick Links section of the Status screen to display the Port Status screen and then click the
Utilization link tab.
Figure 491 Management > Port Status > Utilization (Standalone Mode)
RX Power
(dbm)
This displays the amount of power the SFP transceiver is receiving from the fiber cable.
Current This displays the current status for each monitored DDMI parameter.
High Alarm
Threshold
This displays the high value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
High Warn
Threshold
This displays the high value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Low Warn
Threshold
This displays the low value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Low Alarm
Threshold
This displays the low value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
Table 290 Management > Port Status > DDMI > DDMI Details (continued)
LABEL DESCRIPTION
To Next Page
Loading...
