ZyXEL Communications XGS4600 Series - MLD Snooping-Proxy VLAN

Chapter 25 Multicast
XGS4600 Series User’s Guide
269
Figure 208 Advanced Application > Multicast > IPv6Multicast > MLD Snooping-proxy
The following table describes the fields in the above screen.
25.4.2 MLD Snooping-proxy VLAN
Click the VLAN link in the Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
screen to display the screen as shown. See Section 25.1 on page 257 for more information on
multicasting.
Figure 209 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
The following table describes the fields in the above screen.
Table 106 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy
LABEL DESCRIPTION
MLD Snooping-proxy Use these settings to configure MLD snooping-proxy.
Active Select Active to enable MLD snooping-proxy on the Switch to minimize MLD control
messages and allow better network performance.
802.1p Priority Select a priority level (0 – 7) to which the Switch changes the priority in outgoing MLD
messages.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 107 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN
LABEL DESCRIPTION
VID Enter the ID number of the VLAN on which you want to enable MLD snooping-proxy and
configure related settings.
Upstream