Chapter 3 Hardware Panels
XGS4600 Series User’s Guide
42
1 Use a screwdriver to loosen the terminal block captive screws.
2 Connect one end of a power wire to the Switch’s RTN (return) pin and tighten the captive screw.
3 Connect the other end of the power wire to the positive terminal on the power supply.
4 Connect one end of a power wire to the Switch’s –48 V (input) pin and tighten the captive screw.
5 Connect the other end of the power wire to the negative terminal on the power supply.
6 Insert the terminal block plug in the Switch’s terminal block header.
3.3 LEDs
The following table describes the LEDs.
Table 4 LEDs
LED COLOR STATUS DESCRIPTION
PWR Green On The system is receiving power from the power module in the first power
slot.
Amber Blinking The power module in the first power slot detects that the power system is
under 10.8 voltage or not connected.
Off The system is not receiving power from the power module in the first
power slot.
PWR2 Green On The system is receiving power from the power module in the second
power slot.
Amber Blinking The power module in the second power slot detects that the power
system is under 10.8 voltage or not connected.
Off The system is not receiving power from the power module in the second
power slot.
SYS (System) Green Blinking The system is rebooting and performing self-diagnostic tests.
On The system is on and functioning properly.
Red On The system is functioning abnormally.
Off The power is off or the system is not ready or malfunctioning.
FAN Green On The fan is functioning properly.
Amber On The fan is not functioning at a proper speed or malfunctioning.
Off The fan is removed or the Switch is off.
LOCATOR Blue On The firmware update is in progress. Do not turn off or reset the Switch.
Blinking Shows the actual location of the Switch between several devices in a
rack.
Off The locator function is disabled or the Switch is off.
MAST
(Master)
Green On The Switch is acting as a standalone switch or the master in stacking.
Off The Switch is acting as a non-master member in a stack or it is in
standalone mode.
Amber On There is an error occurred when the Switch is selected as the master
member in a stack.
10/100/1000Base-T Ethernet Ports
To Next Page
Loading...
