ZyXEL Communications XGS4600 Series - Configuring Ipv4 OSPF Interfaces

Chapter 50 OSPF
XGS4600 Series User’s Guide
458
50.7 Configuring IPv4 OSPF Interfaces
To configure an OSPF interface, first create an IP routing domain in the IP Setup screen. Once you create
an IP routing domain, an OSPF interface entry is automatically created. See Section 50.1 on page 448
for more information on OSPF.
In the IPv4 OSPF Configuration screen, click Interface to display the OSPF Interface screen.
Figure 364 IP Application > OSPF > IPv4 OSPF > Configuration > Interface
The following table describes the labels in this screen.
Index This field displays the index number of the summary address.
Summary
address
This field displays the summary IP address.
Subnet mask This field displays the subnet mask for the summary IP address.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Check the rules that you want to remove and then click the Delete button.
Cancel Click Cancel to clear the check boxes.
Table 211 IP Application > OSPF > IPv4 OSPF > Configuration > Redistribute (continued)
LABEL DESCRIPTION
Table 212 IP Application > OSPF > IPv4 OSPF > Configuration > Interface
LABEL DESCRIPTION
Network Select an IP interface.
Area ID Select the area ID (in an IP address format with dotted decimal notation) of an area to
associate the interface to that area.