Chapter 41 Anti-Arpscan
XGS4600 Series User’s Guide
404
•Go to Basic Setting > Port Setup. Clear Active and click Apply. Then select Active and click Apply
again.
•Go to Application > Errdisable > Errdisable Recovery and set the interval for Anti-arpscan. After the
interval expires, the closed ports will become active and start receiving packets again.
• Use the command port no inactive.
• Refer to the port logs to see when a port was closed.
41.2 Anti-Arpscan Status
Use this screen to see what ports are trusted and are forwarding traffic or are disabled. To open this
screen, click Advanced Application > Anti-Arpscan.
Figure 321 Advanced Application > Anti-Arpscan Status (Standalone Mode)
Figure 322 Advanced Application > Anti-Arpscan Status (Stacking Mode)
The following table describes the fields in the above screen.
Table 182 Advanced Application > Anti-Arpscan Status
LABEL DESCRIPTION
Anti-Arpscan is.... This shows whether Anti-arpscan is enabled or disabled on the Switch.
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
To Next Page
Loading...
