Chapter 26 AAA
XGS4600 Series User’s Guide
288
26.5 AAA Setup
Use this screen to configure authentication, authorization and accounting settings on the Switch. Click
on the AAA Setup link in the AAA screen to view the screen as shown.
Figure 226 Advanced Application > AAA > AAA Setup
Timeout Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
Index This is a read-only number representing a TACACS+ accounting server entry.
IP Address Enter the IP address of an external TACACS+ accounting server in dotted decimal notation.
TCP Port The default port of a TACACS+ accounting server is 49. You need not change this value unless
your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters except [ ? ], [ | ], [ ' ], [ " ] or [ , ]) as the
key to be shared between the external TACACS+ accounting server and the Switch. This key is
not sent over the network. This key must be the same on the external TACACS+ accounting
server and the Switch.
Delete Check this box if you want to remove an existing TACACS+ accounting server entry from the
Switch. This entry is deleted when you click Apply.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 115 Advanced Application > AAA > TACACS+ Server Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
