Chapter 25 Multicast
XGS4600 Series User’s Guide
281
25.5.2 MVR Configuration Example
The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN 1. In
addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the News and
Movie channels) from the remote streaming media server, S. Computers A, B and C in VLAN 1 are able
to receive the traffic.
Figure 218 MVR Configuration Example
To configure the MVR settings on the Switch, create a multicast VLAN in the MVR screen and set the
receiver and source ports.
Figure 219 MVR Configuration Example
To set the Switch to forward the multicast group traffic to the subscribers, configure multicast group
settings in the Group Configuration screen. The following figure shows an example where two IPv4
multicast groups (News and Movie) are configured for the multicast VLAN 200.
To Next Page
Loading...
