Chapter 58 Maintenance
XGS4600 Series User’s Guide
525
58.4 Restore Configuration
Use this screen to restore a previously saved configuration from your computer to the Switch.
Figure 433 Management > Maintenance > Restore Configuration
Enter the path and file name of the configuration file you wish to restore in the File Path text box or click
Choose File or Browse to locate it. After you have specified the file, click Restore. "config" is the name of
the configuration file on the Switch, so your backup configuration file is automatically renamed when
you restore using this screen.
58.5 Backup Configuration
Backing up your Switch configurations allows you to create various “snap shots” of your device from
which you may restore at a later date.
Back up your current Switch configuration to a computer using the Backup Configuration screen.
Config Boot Image Select which firmware (Firmware 1 or Firmware 2) should load, click Apply and reboot the
Switch to see changes, you will also see changes in the Current Boot Image field above as
well.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
This field appears only in stacking mode.
Click the drop-down list to choose the slot number of the Switch in a stack to upgrade the
firmware on this slot. Or select All to upgrade the firmware for all slots.
Firmware Choose to upload the new firmware to (Firmware) 1 or (Firmware) 2.
File Path Type the path and file name of the firmware file you wish to upload to the Switch in the File
Path text box or click Choose File or Browse to locate it.
Upgrade Click Upgrade to load the new firmware. s are only applied after a reboot. To reboot, go to
Management > Maintenance > Reboot System and click Config 1, Config 2 or Factory
Default (Config 1, Config 2 and Factory Default are the configuration files you want the
Switch to use when it restarts).
Table 250 Management > Maintenance > Firmware Upgrade (continued)
LABEL DESCRIPTION
To Next Page
Loading...
