ZyXEL Communications XGS4600 Series - Page 524

Chapter 58 Maintenance
XGS4600 Series User’s Guide
524
Figure 432 Management > Maintenance > Firmware Upgrade (Stacking Mode)
The top of firmware upgrade screen shows which firmware version is currently running on the Switch.
Enter the path and file name of the firmware file you wish to upload to the Switch in the File Path text box
or click Choose File or Browse to locate it. Firmware upgrades are only applied after a reboot. Click
Upgrade to load the new firmware. Select the Config Boot Image drop-down list box if you want to
reboot the Switch and click Apply to apply the new firmware immediately. Click Upgrade to load the
new firmware.
After the process is complete, see the System Info screen to verify your current firmware version number.
Table 250 Management > Maintenance > Firmware Upgrade
LABEL DESCRIPTION
Slot This field appears only in stacking mode.
This is the slot index number.
Name This is the name of the Switch that you are configuring.
Status This field appears only in stacking mode.
This field displays the current stacking status on the Switch.
Version The Switch has 2 firmware sets, Firmware 1 and Firmware 2, residing in flash.
• Running shows the version number (and model code) and MM/DD/YYYY creation date
of the firmware currently in use on the Switch (Firmware 1 or Firmware 2). The firmware
information is also displayed at System Information in Basic Setting.
• Firmware 1 shows its version number (and model code) and MM/DD/YYYY creation
date.
• Firmware 2 shows its version number (and model code) and MM/DD/YYYY creation
date.
Current Boot Image This displays which firmware is currently in use on the Switch (Firmware 1 or Firmware 2).