Chapter 57 ARP Setup
XGS4600 Series User’s Guide
514
ARP-Request
When the Switch is in ARP-Request learning mode, it updates the ARP table with both ARP replies,
gratuitous ARP requests and ARP requests.
Therefore in the following example, the Switch can learn host A’s MAC address from the ARP request
sent by host A. The Switch then forwards host B’s ICMP reply to host A right after getting host B’s MAC
address and ICMP reply.
57.2 ARP Setup
Click IP Application > ARP Setup in the navigation panel to display the screen as shown. Click the link
next to ARP Learning to open a screen where you can set the ARP learning mode for each port. Click
the link next to Static ARP to open a screen where you can create static ARP entries on the Switch.
Figure 420 IP Application > ARP Setup
57.2.1 ARP Learning
Use this screen to configure each port’s ARP learning mode. Click the link next to ARP Learning in the IP
Application > ARP Setup screen to display the screen as shown next.
To Next Page
Loading...
