ZyXEL Communications XGS4600 Series - Viewing and Editing Classifier Configuration Summary

Chapter 21 Classifier
XGS4600 Series User’s Guide
236
21.3.1 Viewing and Editing Classifier Configuration Summary
To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the
Classifier screen. To change the settings of a rule, click a number in the Index field.
Note: When two rules conflict with each other, a higher layer rule has priority over lower layer
rule.
Figure 185 Advanced Application > Classifier > Classifier Configuration: Summary Table
The following table describes the labels in this screen.
Layer 4
Specify the fields below to configure a layer 4 classifier.
Source
Socket
Number
Note: You must select either UDP or TCP in the IP Protocol field before you configure the
socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and
enter a TCP/UDP protocol port number.
Destination
Socket
Number
Note: You must select either UDP or TCP in the IP Protocol field before you configure the
socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and
enter a TCP/UDP protocol port number.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if it is turned
off or loses power, so use the Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields back to your previous configuration.
Clear Click Clear to set the above fields back to the factory defaults.
Table 87 Advanced Application > Classifier > Classifier Configuration (continued)
LABEL DESCRIPTION
Table 88 Advanced Application > Classifier > Classifier Configuration: Summary Table
LABEL DESCRIPTION
Index This field displays the index number of the rule. Click an index number to edit the rule.
Active This field displays Yes when the rule is activated and No when it is deactivated.
Weight The field displays the priority of the rule when the match order is in manual mode. A higher weight
means a higher priority.
Name This field displays the descriptive name for this rule. This is for identification purpose only.