Chapter 58 Maintenance
XGS4600 Series User’s Guide
521
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the Switch.
These configurations are set up according to your network environment.
Click Custom Default to save the current configuration settings permanently to a customized default file
on the Switch. If configuration changes cause the Switch to behave abnormally, click Custom Default
(next to Reboot System) to have the Switch automatically reboot and restore the saved Custom Default
configuration file.
Alternatively, click Save on the top right in any screen to save the configuration changes to the current
configuration.
58.2.3 Reboot System
Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or the Factory
Default configuration when you reboot. Follow the steps below to reboot the Switch.
1 In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
configuration file. The confirmation screen displays.
2 Click OK again and then wait for the Switch to restart. This takes up to 2 minutes. This does not affect the
Switch’s configuration.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Stacking Default and follow steps 1 to 2 to reboot and load stacking default configuration settings
on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.
58.2.4 Stacking Default
Follow the steps below to reset the Switch back to the stacking defaults. The master Switch login
information will not be reset.
1 Click the Stacking Default button to clear all Switch configuration information you configured and return
to the stacking defaults.
2 Click OK to continue or Cancel to abort.
To Next Page
Loading...
