Chapter 40 Link Layer Discovery Protocol (LLDP)
XGS4600 Series User’s Guide
392
40.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP Configuration
(Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 311 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting (Standalone Mode)
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable – not allowed
• Tx-Only – transmit only
• Rx-Only – receive only
• Tx-Rx – transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 176 Advanced Application > LLDP > LLDP Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
