Chapter 54 DHCP
XGS4600 Series User’s Guide
495
54.5 DHCPv6 Status
Click IP Application > DHCP > DHCPv6 in the navigation panel to see information on the DHCPv6 server.
The DHCPv6 Status screen displays.
Figure 398 IP Application > DHCP > DHCPv6
The following table describes the labels in this screen.
54.6 DHCPv6 Information
Use this screen to configure DHCPv6 and DNS server settings on the Switch. Click IP Application > DHCP >
DHCPv6 > Information in the navigation panel to display the screen as shown.
Figure 399 IP Application > DHCP > DHCPv6 > Information
Table 237 IP Application > DHCP > DHCPv6
LABEL DESCRIPTION
Server Status This section displays configuration settings related to the Switch’s DHCP server mode.
Index This is the index number of a DHCPv6 server information.
VID This field displays the VLAN ID to which the DHCP server belongs.
DHCP Server A DHCPv6 server can assign and pass IPv6 network addresses, prefixes and other
configuration information to DHCP clients.
Information This field displays Yes when the entry supports display of the refresh time and DNS server; it
shows No when it does not.
Prefix
Delegation
This field displays Yes when the entry supports the prefix delegation; it shows No when it does
not. The prefix delegation is used by an IPv6 device to generate its IP address.
DHCP Relay A DHCPv6 relay agent is on the same network as the DHCPv6 clients and helps forward
messages between the DHCPv6 server (that’s in another network) and the DHCPv6 clients.
This field displays Yes when the Switch supports DHCPv6 Relay and No when it does not. Yes
means the Switch forwards all DHCP requests to the same DHCP server. No means the Switch
does not forward DHCP requests to a DHCP server.
To Next Page
Loading...
