Chapter 57 ARP Setup
XGS4600 Series User’s Guide
516
57.2.2 Static ARP
Use this screen to create static ARP entries that will display in the Management > ARP Table screen and
will not age out. Click the link next to Static ARP in the IP Application > ARP Setup screen to display the
screen as shown.
Figure 423 IP Application > ARP Setup > Static ARP (Standalone Mode)
Figure 424 IP Application > ARP Setup > Static ARP (Stacking Mode)
ARP Learning
Mode
Select the ARP learning mode the Switch uses on the port.
Select ARP-Reply to have the Switch update the ARP table only with the ARP replies to the ARP
requests sent by the Switch.
Select Gratuitous-ARP to have the Switch update its ARP table with either an ARP reply or a
gratuitous ARP request.
Select ARP-Request to have the Switch update the ARP table with both ARP replies, gratuitous
ARP requests and ARP requests.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 247 IP Application > ARP Setup > ARP Learning (continued)
LABEL DESCRIPTION
To Next Page
Loading...
