ZyXEL Communications XGS4600 Series - One Subnet Network Example; VRRP Configuration Examples

Chapter 55 VRRP
XGS4600 Series User’s Guide
506
55.4 VRRP Configuration Examples
The following sections show two VRRP configuration examples on the Switch.
55.4.1 One Subnet Network Example
The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1) and two
switches. The network is connected to the WAN through an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Figure 409 VRRP Configuration Example: One Virtual Router Network
You want to set switch A as the master router. Configure the VRRP parameters in the VRRP Configuration
screens on the switches as shown in the figures below.
Figure 410 VRRP Example 1: VRRP Parameter Settings on Switch A
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the check boxes.
Table 245 IP Application > VRRP Configuration: Summary (continued)
LABEL DESCRIPTION
EXAMPLE