ZyXEL Communications XGS4600 Series - Anti-Arpscan Configure; Anti-Arpscan Trust Host

Chapter 41 Anti-Arpscan
XGS4600 Series User’s Guide
406
41.4 Anti-Arpscan Trust Host
Use this screen to create or remove trusted hosts identified by IP address and subnet mask. Anti-arpscan
is not performed on trusted hosts. To open this screen, click Advanced Application > Anti-Arpscan > Trust
Host.
Figure 324 Advanced Application > Anti-Arpscan > Trust Host
The following table describes the fields in the above screen.
41.5 Anti-Arpscan Configure
Use this screen to enable Anti-Arpscan, set port and host thresholds as well as configure ports to be
trusted or untrusted. To open this screen, click Advanced Application > Anti-Arpscan > Configure.
Table 184 Advanced Application > Anti-Arpscan > Trust Host
LABEL DESCRIPTION
Name Type a descriptive name of up to 32 printable ASCII characters to identify this host.
Host IP Type the IP address of the host.
Mask A trusted host may consist of a subnet of IP addresses. Type a subnet mask to create a
single host or a subnet of hosts.
Add Click this to create the trusted host.
Cancel Click this to reset the values above based or, if not applicable, to clear the fields above.
Clear Click this to clear the fields above.
Index This field displays a sequential number for each trusted host.
Name This field displays the name of the trusted host.
Host IP This field displays the IP address of the trusted host.
Mask This field displays the subnet mask of the trusted host.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Delete Select an entry check box and click Delete to remove the specified entry.
Cancel Click this to clear the check boxes above.