Chapter 8 Basic Setting
XGS4600 Series User’s Guide
83
CHAPTER 8
Basic Setting
8.1 Overview
This chapter describes how to configure the System Info, General Setup, Switch Setup, IP Setup, Port
Setup, Interface Setup, IPv6, and Cloud Management screens.
8.1.1 What You Can Do
• Use the System Info screen (Section 8.2 on page 83) to check the firmware version number and
monitor the Switch temperature.
• Use the General Setup screen (Section 8.3 on page 87) to configure general settings such as the
system name and time.
• Use the Switch Setup screen (Section 8.5 on page 90) to choose your VLAN type and assign priorities
to queues.
• Use the IP Setup screen (Section 8.6 on page 92) to configure the Switch IP address, default gateway
device, management VLAN ID, and proxy server.
• Use the Port Setup screen (Section 8.7 on page 97) to configure Switch port settings.
• Use the Interface Setup screens (Section 8.8 on page 99) to configure Switch interface type and
interface ID settings.
• Use the IPv6 screens (Section 8.9 on page 100) to view IPv6 status and IPv6 configuration.
• Use the Loopback Interface screen (Section 8.10 on page 114) to configure the IPv4 loopback
interface settings on the Switch.
• Use the Stacking screen (Section 8.11 on page 115) to view and configure stacking system for the
Switch.
8.2 System Information
In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use this screen
to view general system information.
To Next Page
Loading...
