Chapter 58 Maintenance
XGS4600 Series User’s Guide
520
58.2.1 Erase Running-Configuration
Follow the steps below to clear current configuration on the Switch. Note that this will NOT reset the
Switch back to its factory defaults. For example, if your Switch is set to stacking mode and you click
erase running-configuration, after the Switch restarts, it will remain in stacking mode. If you want to
change the Switch to its factory default mode, click the Factory Default button in Reboot System.
1 In the Maintenance screen, click the Click Here button next to Erase Running-Configuration to clear all
Switch configuration information you configured and return to the Zyxel default configuration settings.
2 Click OK to reset all Switch configurations.
Figure 427 Erase Running-Configuration: Confirmation
3 In the Web Configurator, click the Save button in the top of the screen to make the changes take
effect. If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1
or DHCP-assigned IP).
58.2.2 Save Configuration
Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
These configurations are set up according to your network environment.
Reboot System Click Config 1 to reboot the system and load Configuration 1 on the Switch.
Click Config 2 to reboot the system and load Configuration 2 on the Switch.
Click Stacking Default to reboot the system and load stacking configurations on the Switch.
Click Factory Default to reboot the system and load the factory default configuration on the
Switch.
Click Custom Default to reboot the system and load a saved Custom Default configuration file
on the Switch. This will save the custom default configuration settings to both Configuration 1
and Configuration 2. If a Custom Default configuration file was not saved, clicking Custom
Default loads the factory default configuration on the Switch.
Note: Make sure to click the Save button in any screen to save your settings to the
current configuration on the Switch.
Current This field displays which configuration (Configuration 1 or Configuration 2) is currently operating
on the Switch.
Tech-Support Click Click Here to see the Tech-Support screen. You can set CPU and memory thresholds for
log reports and download related log reports for issue analysis. Log reports include CPU history
and utilization, crash and memory.
Certificates Click Click Here to see the Certificate screen and import the Switch's CA-signed certificates.
Table 249 Management > Maintenance (continued)
LABEL DESCRIPTION
To Next Page
Loading...
