ZyXEL Communications XGS4600 Series - Destination

Chapter 16 Mirroring
XGS4600 Series User’s Guide
193
The following table describes the labels in this screen.
16.1.3 Destination
Use this screen to specify the RMirror VLAN and configure the monitor port when the Switch is the
destination device in remote port mirroring.
Click the Destination link in the RMirror screen. The following screen opens.
Table 71 Advanced Application > Mirroring > RMirror > Source
LABEL DESCRIPTION
RMirror VLAN ID Select the RMirror VLAN over which the mirrored traffic is forwarded.
Priority Enter the priority of the mirrored traffic.
Reflector Port Select the check box to enable the specified reflector port.
Enter the number of reflector port that adds the RMirror VLAN tag to all mirrored traffic and
forwards traffic to the connected ports in the same RMirror VLAN.
In stacking mode, the first box field is the slot ID and the second field is the port number.
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last
two ports of your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Mirrored Select this option to mirror the traffic on a port.
Direction Specify the direction of the traffic to mirror by selecting from the drop-down list box.
Choices are Egress (outgoing), Ingress (incoming) and Both.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
VLAN This field displays the ID number of RMirror VLAN over which the mirrored traffic is
forwarded.
Priority This field displays the priority of the mirrored traffic.
Mirror Port
Ingress This field displays the number of ports on which the incoming traffic is mirrored.
Egress This field displays the number of ports on which the outgoing traffic is mirrored.
Both This field displays the number of ports on which the incoming and outgoing traffic is
mirrored.
Reflector Port This field displays whether the reflector port is enabled and the number of reflector port in
this RMirror VLAN.